You ARE accounting for them, right?

You ARE accounting for them, right?
While diagnosing an electrical issue last week, I suspected that the battery was tired. The terminals were banged up, the case was covered in grime, and the manufacturer’s decal was peeling and faded. It barely passed a quick health check, so I started looking for a...
Description Chefs know a helpful hack to keep spaghetti from falling out of an opened bag, and the same idea happens to work perfectly for zip ties. Give it a try next time you have a pack of zip ties that doesn’t have a resealable closure.Related Videos
Recently I was organizing my books on a new bookshelf and came across one that I had almost forgotten about. I picked it up after seeing an exhibition called “See the USA: Automobile Travel and the American Landscape” at the Building Museum when I lived in D.C. The...
Description Which of the following statements about piston rings is incorrect? A) End gaps must be evenly spaced around the piston B) Rings are installed on the piston using a ring compressor C) Rings must be installed facing the correct vertical direction D) End gap...
Of all the fluids a vehicle needs, the brake fluid is arguably the most important. Inspecting your customers’ brake fluid is vital to the continued safe operation of the braking system. It’s a service you should perform not only when you’re servicing the brakes but as...
Description The Rust Belt and the Salt Belt may sound similar, and you might even hear them used interchangeably, but they are distinct names that any automotive professional or enthusiast should know. Take a few seconds to get the real story on these terms.Related...
Description Auto repair pros probably know the expression “buy once, cry once,” and for some tools, techs should buy the best they can afford. In other cases, cheap and basic versions will be just fine. So which tools are worthy of serious investment? Nick, Miriam,...
Description An engine exhibits a knocking noise. During a cylinder power balance test, the noise abates. Technician A says the noise is likely worn big-end bearings on the connecting rod. Technician B says the noise is likely piston slap. Who is correct?More ASE...
The page you requested could not be found. Try refining your search, or use the navigation above to locate the post.